The “no buffer” indicates the number of failures from block allocations. The number of packets and bytes received on this interface. This is the interfaces IP address and subnet mask. If the interface name is not set the MTU will display “MTU not set”. This is the interfaces MAC address and configured MTU. On a multi context firewall, in the system context you might see the following message: Available for allocation to a context If an interface is a member of a redundant interface, you see the following message: Active member of Redundant5 If you do not configure a name, you see the following message: Available but not configured via nameif If the line is up the negotiated or actual values will be in parenthesis. If the line is down, the configured values are displayed. VCS7380 – Vitesse Four Port Gigabit Switch used in SSM-4GEĭisplayed on this line is also the maximum bandwidth and delay that can be on this interface.ĭuplex and speed settings.i82559 – Intel PCI Copper Fast Ethernet used on PIX platforms.i82557 – Intel PCI Copper Fast Ethernet used on ASA platforms.
i82547GI – Intel CSA Copper Gigabit used as backplane on ASA platforms. i82546GB – Intel PCI-X Copper Gigabit used on ASA platforms. i82543 – Intel PCI-X Fiber Gigabit card used on PIX platforms. i82542 – Intel PCI Fiber Gigabit card used on PIX platforms. Hardware is the chip type used in the interface. The like protocol status is either up (indicating there is a working cable plugged into the interface) or down (indicating the cable is either unplugged or incorrect). The “is up” status can be up or administratively down. Output queue (blocks free curr/low): hardware (254/0)Ģ4943662 packets output, 28202920165 bytesġ minute input rate 178 pkts/sec, 18825 bytes/secġ minute output rate 267 pkts/sec, 306674 bytes/secĥ minute input rate 255 pkts/sec, 16417 bytes/secĥ minute output rate 422 pkts/sec, 548955 bytes/sec Input queue (blocks free curr/low): hardware (255/230) Received 111 broadcasts, 0 runts, 0 giantsĠ input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abortĢ4943232 packets output, 28662026144 bytes, 430 underrunsĠ output errors, 0 collisions, 0 interface resetsĠ input reset drops, 0 output reset drops, 0 tx hangs Input flow control is unsupported, output flow control is off Hardware is i82546GB rev03, BW 1000 Mbps, DLY 10 usecįull-Duplex(Full-duplex), 100 Mbps(100 Mbps) Interface GigabitEthernet0/1 "inside", is up, line protocol is up 
USS-ASA/pri/act# sh int GigabitEthernet0/1
0 kommentar(er)
